您的浏览器版本太低

         what need to care in design of medical connectors and cables
There are many types of medical devices, so there are many factors to consider when designing a medical connector cable.

 1. Connectors or cable designed to be the same as the original factory.There are many customers who do maintenance or act as agents for the original medical equipment with the original product to do the design.

First, whether the product has a patent or not.If you have a patent on the appearance or a patent on the structure you need to be careful.There are also some customers require size design with the original factory exactly the same, you know, is the same manufacturer with the same batch of products will have tolerance, let alone take the original factory's product copy number.

Second, there is the question of cost.A lot of original products are used with better materials, some domestic, can only be imported.The cost will be high and the customer will not accept it.Special attention should be paid to the possibility that some materials may involve some political factors and may be out of stock at any time.Before the project starts, we must make it clear to the customer that domestic products can be replaced by domestic ones.

Third, there is the issue of structure.Many products have complex structural design. If they are designed to be the same, have you considered the problem of production and processing?The accessories designed must be convenient for production and processing.If it is not good for production and processing, the defective rate of products will be very high, and the production efficiency will be very low, directly causing the cost increase.

2. The host equipment has been developed by the customer and it needs a complete set of connectors and cables.
This design case is relatively simple, first consider the use of customer equipment environment, do not need to waterproof, salt spray resistance, etc.Determine the good use environment, it is good to choose the structure of the connector and the material of the connecting line.

Second, determine the use of equipment.Do not need to use frequently, if often used, recommended to design a push-pull self-locking structure.If you do not use it frequently, you can use thread locking similar to the M8 connector.

Third, determine the size of the connector cable that the customer can use.This determines the connector interface type.

3. Customers' products are in the design and development stage or only have plans.
This type of design is the most complex, requiring many factors to be considered.The design must be mindful of the client's host equipment, not just connectors and cables.If something needs to be changed, the entire connector and cable may need to be knocked down and redesigned, which requires special attention.